As we haven’t used any moisture to clean the brush bar or floorhead, this can be done immediately without needing to wait for it to dry.. Slide the brush bar into the floorhead.
Lots of dirt and debris will fall out during the cleaning process, so it’s easier just to throw away the newspaper at the end..Step 2: Clean The V7’s Dust Canister and Main Body.
Before we start the cleaning process, it’s vital to point out that the motor, battery, and other electrical components should.never be cleaned with water.Water could permanently damage your Dyson V7’s electronics and may also be dangerous when you switch the vacuum back on..
So, be careful when cleaning your Dyson!As a general rule, you should only use water on components that you can verify are completely plastic without any electronics (e.g.
the dust canister).. With that out of the way, here’s how to clean the main body of your Dyson V7:.
Carefully rinse the dust canister in cold water to remove dust and dirt.When to Hire a Professional.
If your carpet is drenched in a lot of water (such as from a burst pipe,) then it’s best to hire a professional with access to a water extraction machine..The longer that water is left to sit in the carpet, the more likely it is that mould or mildew could start to grow (this process can start in around 24-48 hours.)
You probably won’t be able to dry a severely damp carpet fast enough to prevent mould unless you have professional equipment..If your carpet has affected by a burst sewer pipe, then you shouldn’t use any of the methods above.
(Editor: Powerful Dehumidifiers)